Shaker Dining Table Shaker Style Dining Table

Shaker Dining Table Shaker Style Dining Table Shaker Dining Table Shaker Style Dining Table

Bathroom Renovation - A Step by Step Guide

Bathrooms are probably the smallest rooms inside your home and they are also certainly the most expensive to renovate. Bathroom renovation can be a job that, if done well, can add value to your home and a great space filled with design and light.
Shaker Dining Table  Shaker Style Dining Table

Bathroom design
Bathroom design will be the first part of a bath room renovation you should get right. Just replacing the current bathroom with the exact same design may not be enough. The key to great bathroom design is to design it using the people that are going to apply it in your mind. However make certain that a bath room design also offers an over-all use factor at the same time.

For example: If you were designing your bathroom for families you may still design the toilet with comfortable access towards the shower and bath. This would make certain that the style would recieve treatment if you have limited mobility. This means if you choose to sell your property or if you are renovating for profit your design has a wider market appeal. Great bathroom design also uses the space well, taking into account the light or window space, size fittings, and drainage options. Draw out a strategy to scale and all the way down the sizes of your respective room. Mark the existing drainage points then and water inlet points. Write down a wish list of the toilet fittings to wish and need using their sizes. Now marry both the together to see what fits. Note: Most bathroom drainage and water inlet points could be moved but this does come at extra expense.
Shaker Style Dining Table : Lot 159

Bathroom remodel
If you've decided to perform the task yourself or part of the project it really is time to work with a skip bin and pull out that old bathroom. If your own home appeared pre 1980 you could have fibro bathroom wall linings with asbestos within it and great care will need to be taken. You will need some full body disposable overalls, eye protection, and quality dust mask. Check with your neighborhood building authority or council in connection with regulation on bathroom asbestos wall lining removal.
Remove everything except the plumbing. If you keep the toilet plumbing set up you won't must turn the river off for the whole house. Also you will need to jack hammer a floor tiles up and the sand and cement bed that they're laid on.
Shaker Dining Room Table  Erik Organic

Bathroom Renovation and construction
Bathrooms have to be construction properly through the ground up to ensure that the finished job is correct and true. This also ensures the structure and appearance of the lavatory can have a great finish
The Bathroom Renovation Process

Install water and drainage pipe and electrical wires.

Install wall lining and ceiling then install the bath hob and bath.

Waterproof the bottom and shower and bath recess.

Correct december the floor with sand and cement ready for tiling.

Lay floor and wall tiles and then grout.

Install new bathroom vanity, fittings, and taps - install new electrical.
Shaker Mission Dining Table  Amish Direct Furniture


Paint ceiling and final  one - Plumbing and electrical
At this aspect new plumbing is installed for clean hot and cold water and drainage. Careful attention has to be taken when positioning the modern plumbing so that the plumbing fittings are correct if the tiling is finished. For example: To centre a fitting in a shower recess you must consider the thickness of the wall board, tile glue and tile so the fitting will probably be centred as soon as the tiles are available. The same relates to installing drainage pipes to get a toilet; the wall lining and tile thickness must be taken into account so the pipe is in the correct position if the toilet is installed after tiling. Also rough in the any new electrical wires without connecting them towards the mains power.
BW Shaker Dinig

Step two - Install wall and ceiling linings
Install your 6mm wall lining being careful to nail the fibro board every 150mm without nailing into the newest pipes and electrical wires. The best way would be to measure and mark the pipe and wire layout on your new wall board with a pencil while you go. Screw up (or nail) the ceiling lining, plasterboard could be the most common. However if you happen to be laying your tiles from floor to ceiling don't install the cornice as this is most effectively achieved after tiling. If you're not tiling to the ceiling just install the cornice as soon as the wallboard and ceiling lining have been installed. Also if your bath is just not freestanding you can now form the frame and install the tub. Ensure the bath is installed correctly allowing for the thickness from the tiles and  sure to check all linings and pipes when you continue with your bathrooms renovation.

Shaker Style Dining Table : Lot 159
Shaker Dining Table  Shaker Style Dining Table

Step three - Waterproof a bath room
Waterproof your bathroom floor, shower recess, and around the bath. When waterproofing a floor be sure that the waterproofing comes 100mm up the walls. The shower recess must be waterproofed 100mm higher than the shower rose outlet. Also the bath should be waterproofed 100mm across the lip from the bath right around and to the floor. At the doorway install a 25 x 25mm aluminum angle glued into place with quality silicone and waterproof to the lip. Your whole bathroom should now the tanked, and so the all water will still only go down a drain. Bathroom waterproofing tip: waterproofing is a straightforward job but quality and accuracy is most significant.
Step four - Lay inside the cement screed for the bottom.

Before a floor tiles can laid the floor must be smooth and fairly flat which has a slight fall for the drainage outlet. To do this you must use sand and cement mix and it's also best to add a waterproofing agent into this too. With a level, set the floor level on the doorway. Use the top aluminum angle as the finished floor level and measure along the thickness with the tile plus 10mm for your glue. Mark right around the restroom with a level and after that screed within your sand and cement mix having a 1 to 3 degree fall for the top with the drain outlet. Take your time and have it right with the finished level as smooth as is possible. When the sand cement mix has set but isn't dry (you can walk into it nevertheless, you it's still a bit soft) rub it over using a house brick. This will remove every one of the small highs and lows and look having a level as you go. Let the restroom floor fully dry after which you needs to have a great surface to tile onto. Tip: the greater work you put into the bottom screed the more your tiling will be.
Shaker Dining Room Table Erik Organic
Shaker Style Dining Table : Lot 159

Step five: Tile floor and walls
Lay your tiles on the ground first and after that grout. Then lay your wall tiles making sure actually level because you lay. Once the toilet tiles happen to be cut and laid, grout all of your tiles after which buff the tiles clean.
Step six: Install plumbing fitting and fixtures
Install all of your plumbing fittings and taps. Also fit all of your towel rails and soap holders. Fit your new bathroom vanity making certain it really is level and sealed across the top with silicone and also seal around the tub. Tip: make sure they will be in the right place before you decide to drill into your tiles.
Shaker Mission Dining Table Amish Direct Furniture
Shaker Dining Room Table  Erik Organic

Step seven: painting, and cleaning - enjoy
Paint your ceiling and perform a final clean making certain things are all fitted correctly which there are no leaks in your plumbing. - Enjoy your bathroom.

Comments