مداخل فلل لن تصدق جمالها ديكور بلس

Exterior Home Designers Interior And Exterior Designers In Bangalore Dayri مداخل فلل لن تصدق جمالها ديكور بلس

Bathroom Renovation - A Step by Step Guide

Bathrooms are some of the smallest rooms at home and they are also the most costly to renovate. Bathroom renovation is really a job that, if done well, can also add value to your home as well as a great space full of design and lightweight.
مداخل فلل  لن تصدق جمالها  ديكور بلس

Bathroom design
Bathroom design may be the first division of your bathrooms renovation you need to get right. Just replacing the prevailing bathroom with the exact same design is probably not enough. The key to great bathroom design is always to design it while using folks that are going to put it to use in mind. However make certain that your bathrooms design also has a general use factor also.

For example: If you were designing a bathroom for families you could still design the toilet with quick access on the shower and bath. This would make certain that the structure would also work if you have limited mobility. This means if you decide to sell your house or if you're renovating for profit your design has a wider market appeal. Great bathroom design also uses the area well, looking at the sunlight or window space, sized fittings, and drainage options. Draw out an agenda to scale and right down the sizes of your room. Mark the present drainage points and then and water inlet points. Write down a wish set of the toilet fittings to need and desire making use of their sizes. Now marry both the together and see what fits. Note: Most bathroom drainage and water inlet points can be moved but this certainly does come at extra cost.
Arc Space Design Gallery

Bathroom remodel
If you have chosen to complete the work yourself or part of the work it can be time to employ a skip bin and retrieve the old bathroom. If your property was developed pre 1980 you could have fibro bathroom wall linings with asbestos within it and great care will have to be taken. You will need some full body disposable overalls, eye protection, and quality dust mask. Check with the local building authority or council in connection with regulation on bathroom asbestos wall lining removal.
Remove everything except the plumbing. If you keep the bathroom plumbing set up you will not need to turn the river off for the complete house. Also you should jack hammer a floor tiles up and also the sand and cement bed they are laid on.
3d Building Elevation Bangalore  Building Elevation in 2019  House front design, Building

Bathroom Renovation and construction
Bathrooms has to be construction properly in the start to be sure that the finished job is correct and true. This also ensures the style and appear of the restroom will have a great finish
The Bathroom Renovation Process

Install water and drainage pipe and electrical wires.

Install wall lining and ceiling then install the bath hob and bath.

Waterproof the bottom and shower and bath recess.

Correct nov the ground with sand and cement ready for tiling.

Lay floor and wall tiles after which grout.

Install new bathroom vanity, fittings, and taps - install new electrical.
Top 50 Modern House Designs  Modern House Designs 2016  YouTube


Paint ceiling and final  one - Plumbing and electrical
At this time brand new plumbing is installed for clean cold and warm water and drainage. Careful attention should be taken when positioning the modern plumbing in order that the plumbing fittings are correct if the tiling is completed. For example: To centre a fitting in the shower recess you need to take into account the thickness in the wall board, tile glue and tile so the fitting will likely be centred after the tiles are available. The same relates to installing drainage pipes for a toilet; the wall lining and tile thickness should be taken into consideration so the pipe influences correct position once the toilet is installed after tiling. Also rough in the any new electrical wires without connecting them towards the mains power.
Portfolio Archive Hi Living 3d Concept Of Villa Resort Interior Design Designers In Bangalore

Step two - Install wall and ceiling linings
Install your 6mm wall lining being careful to nail the fibro board every 150mm without nailing into the brand new pipes and electrical wires. The best way would be to measure and mark the pipe and wire layout onto your new wall board having a pencil as you go. Screw up (or nail) the ceiling lining, plasterboard is the most common. However if you happen to be laying your tiles from floor to ceiling don't install the cornice as this is best done after tiling. If you're not tiling for the ceiling just install the cornice following your wallboard and ceiling lining happen to be installed. Also if your bath just isn't freestanding now you can form the frame and install the bath. Ensure the tub is installed correctly allowing for the thickness of the tiles and  sure to evaluate all linings and pipes before you decide to continue with your bathroom renovation.

Arc Space Design Gallery
مداخل فلل  لن تصدق جمالها  ديكور بلس

Step three - Waterproof your bathroom
Waterproof your bathroom floor, shower recess, and around the bath. When waterproofing the bottom make certain that the waterproofing comes 100mm in the walls. The shower recess should be waterproofed 100mm above the shower rose outlet. Also the bath must be waterproofed 100mm higher than the lip of the bath right around and for the floor. At the doorway use a 25 x 25mm aluminum angle glued into place with quality silicone and waterproof in to the lip. Your whole bathroom should now the tanked, so the all water is only going to drop a drain. Bathroom waterproofing tip: waterproofing is an easy job but quality and accuracy is most critical.
Step four - Lay inside the cement screed for the floor.

Before the bottom tiles can laid a floor have to be smooth and fairly flat having a slight fall to the drainage outlet. To do this you must use sand and cement mix which is advisable to add a waterproofing agent into this at the same time. With a level, set the ground level on the doorway. Use the top aluminum angle because finished floor level and measure down the thickness from the tile plus 10mm for your glue. Mark around the restroom using a level and then screed inside your sand and cement mix with a 1 to 3 degree fall on the top of the drain outlet. Take your time and acquire it right while using finished level as smooth as you can. When the sand cement mix has set but is just not dry (you can walk about it but you it is a little soft) rub it over which has a house brick. This will remove all the small highs and lows and appearance which has a level while you go. Let the lavatory floor fully dry and then you really should have an incredible surface to tile onto. Tip: the greater work you add into the ground screed the easier your tiling will likely be.
3d Building Elevation Bangalore Building Elevation in 2019 House front design, Building
Arc Space Design Gallery

Step five: Tile floor and walls
Lay your tiles on the ground first then grout. Then lay your wall tiles making certain actually level while you lay. Once the lavatory tiles happen to be cut and laid, grout your tiles then buff the tiles clean.
Step six: Install plumbing fitting and fixtures
Install your entire plumbing fittings and taps. Also fit all of your towel rails and soap holders. Fit your brand-new bathroom vanity ensuring it is level and sealed across the top with silicone and also seal around the bath. Tip: make sure they have been in the right place before you drill in your tiles.
Top 50 Modern House Designs Modern House Designs 2016 YouTube
3d Building Elevation Bangalore  Building Elevation in 2019  House front design, Building

Step seven: painting, and cleaning - enjoy
Paint your ceiling and perform final clean making certain things are fitted correctly and that there aren't any leaks in your plumbing. - Enjoy a new bathroom.

Comments