Wimbledon Hill Parks Show Home Hunter – Windsor

Urban Bedroom Designs Gray Urban Bedroom | Interior Design Ideas Wimbledon Hill Parks Show Home Hunter – Windsor

Bathroom Renovation - A Step by Step Guide

Bathrooms are among the smallest rooms inside your home and they're also one the most expensive for renovate. Bathroom renovation can be a job that, if done well, can also add value to a home as well as a great space filled with design and lightweight.
Wimbledon Hill Parks Show Home  Hunter – Windsor

Bathroom design
Bathroom design could be the first part of a bath room renovation you need right. Just replacing the existing bathroom with the same design will not be enough. The key to great bathroom design is usually to design it while using people who are going to use it planned. However make sure that your bathrooms design also has a general use factor at the same time.

For example: If you were designing your bathroom for families you can still design the bathroom with comfortable access towards the shower and bath. This would ensure that the look would recieve treatment for those who have limited mobility. This means if you sell your property or if you are renovating for profit your design includes a wider market appeal. Great bathroom design also uses the room well, taking into consideration the light or window space, height and width of fittings, and drainage options. Draw out a strategy to scale and all the way down the sizes of your room. Mark the existing drainage points and then and water inlet points. Write down a wish report on the lavatory fittings to wish and want using their sizes. Now marry the 2 together and discover what fits. Note: Most bathroom drainage and water inlet points can be moved but this certainly does come at expense.
Interior Design Ideas Executive Office  YouTube

Bathroom remodel
If you have chosen to perform the work yourself or part of the task it can be time to engage a skip bin and take out the existing bathroom. If your house was developed pre 1980 you may have fibro bathroom wall linings with asbestos within it and great care will need to be taken. You will need some full body disposable overalls, eye protection, and quality dust mask. Check with your local building authority or council in connection with regulation on bathroom asbestos wall lining removal.
Remove everything except the plumbing. If you keep the restroom plumbing available you do not ought to turn the lake off for the whole house. Also you should jack hammer a floor tiles up along with the sand and cement bed that they're laid on.
13 Stylish Restaurant Interior Design Ideas Around The World

Bathroom Renovation and construction
Bathrooms must be construction properly through the ground up to be sure that the finished job is correct and true. This also ensures the design and appear of the lavatory may have an incredible finish
The Bathroom Renovation Process

Install water and drainage pipe and electrical wires.

Install wall lining and ceiling and after that install the bath hob and bath.

Waterproof the bottom and shower and bath recess.

Correct december the floor with sand and cement ready for tiling.

Lay floor and wall tiles then grout.

Install new bathroom vanity, fittings, and taps - install new electrical.
Loke Thye Kee Residences: Recapturing Historic Penang with Modern Zest


Paint ceiling and final  one - Plumbing and electrical
At this point many new plumbing is installed for clean cold and hot water and drainage. Careful attention needs to be taken when positioning the modern plumbing so that the plumbing fittings are correct when the tiling is finished. For example: To centre a fitting in a shower recess you have to take into consideration the thickness in the wall board, tile glue and tile so the fitting will probably be centred following the tiles are in place. The same applies to installing drainage pipes for a toilet; the wall lining and tile thickness must be taken into account therefore the pipe influences correct position if the toilet is installed after tiling. Also rough inside any new electrical wires without connecting them on the mains power.
Willman Interiors  Hawaii Interior Designer

Step two - Install wall and ceiling linings
Install your 6mm wall lining the constant maintenance to nail the fibro board every 150mm without nailing into the newest pipes and electrical wires. The best way is to measure and mark the pipe and wire layout on to your new wall board which has a pencil as you go. Screw up (or nail) the ceiling lining, plasterboard may be the most common. However if you happen to be laying your tiles from floor to ceiling don't install the cornice because this is done after tiling. If you are not tiling for the ceiling go ahead and install the cornice after the wallboard and ceiling lining have been installed. Also if your bath just isn't freestanding now you can make up the frame and install the bath. Ensure the tub is installed correctly permitting the thickness with the tiles and  sure to test all linings and pipes before you continue with a bath room renovation.

Interior Design Ideas Executive Office YouTube
Wimbledon Hill Parks Show Home  Hunter – Windsor

Step three - Waterproof your bathrooms
Waterproof a bath room floor, shower recess, and around the tub. When waterproofing the bottom make certain that the waterproofing comes 100mm in the walls. The shower recess must be waterproofed 100mm over the shower rose outlet. Also the bathtub needs to be waterproofed 100mm across the lip with the bath about and on the floor. At the doorway install a 25 x 25mm aluminum angle glued into place with quality silicone and waterproof into the lip. Your whole bathroom should now the tanked, therefore the all water will only decrease a drain. Bathroom waterproofing tip: waterproofing is a straightforward job but quality and accuracy is most critical.
Step four - Lay in the cement screed for the ground.

Before the ground tiles can laid a floor have to be smooth and fairly flat with a slight fall towards the drainage outlet. To do this you need to use sand and cement mix which is better to put in a waterproofing agent into this as well. With a level, set the ground level in the doorway. Use the top aluminum angle since the finished floor level and measure around the thickness with the tile plus 10mm for that glue. Mark right around the bathroom having a level then screed with your sand and cement mix which has a 1 to 3 degree fall to the top of the drain outlet. Take your time and obtain it right with all the finished level as smooth as is possible. When the sand cement mix has set but just isn't dry (you are able to walk into it however, you will still be somewhat soft) rub it over with a house brick. This will remove all of the small highs and lows and appearance which has a level because you go. Let the restroom floor fully dry and after that you really should have an excellent surface to tile onto. Tip: the harder work you add into the bottom screed the easier your tiling is going to be.
13 Stylish Restaurant Interior Design Ideas Around The World
Interior Design Ideas Executive Office  YouTube

Step five: Tile floor and walls
Lay your tiles on the ground first after which grout. Then lay your wall tiles ensuring they are level as you lay. Once the bathroom tiles are actually cut and laid, grout all of your tiles then buff the tiles clean.
Step six: Install plumbing fitting and fixtures
Install your entire plumbing fittings and taps. Also fit your entire towel rails and soap holders. Fit your bathroom vanity making certain it can be level and sealed across the top with silicone as well as seal around the tub. Tip: make sure they will be in the right place before you drill into the tiles.
Loke Thye Kee Residences: Recapturing Historic Penang with Modern Zest
13 Stylish Restaurant Interior Design Ideas Around The World

Step seven: painting, and cleaning - enjoy
Paint your ceiling and execute a final clean making certain everything is fitted correctly and that there won't be any leaks with your plumbing. - Enjoy your bathroom.

Comments